Floor Finish Stripper
CT – FloorStrip HP – Labor saving high performance floor finish stripper

CT-FloorStrip HP is a highly effective labor saving stripper that virtually eliminates the need for floor machines, pads, and rinsing. It will solubilize aged and built-up finishes and waxes almost instantly. This high performance floor stripper is designed to remove floor finish, water-based coatings and sealers from heavily burnished floors. May be used as a no-scrub floor stripper or with a conventional floor machine and pad depending on the condition of the floor. Can be sprayed on cove moldings to soften and remove accumulations of old finishes and wax.

CT-FloorStrip HP is sold as concentrate. The required dilution will depend on the build-up and age of the polish film. As a starting point dilute with warm water as follows:

FOR AVERAGE BUILD-UPS: Dilute 1 to 4 with water.
FOR MODERATE BUILD-UPS: Dilute 1 to 3 with water.
FOR HEAVY AGED BUILD-UPS: Dilute 1 to 2 with water.

FOR USE WITH A FLOOR MACHINE: Dilute 1 to 8-16 parts water. Mop a generous solution onto the floor to be stripped. Allow solution to stand about 5 minutes keeping the floor wet at all times. If mop stripping then agitate with the mop. If using an automatic scrubber or rotary floor machine, no mop agitation is required. Pick-up the solution with a wet vacuum, automatic scrubber or clean mop. Rinse with freshwater and allow floor to dry thoroughly prior to applying any sealer or finish.

Coverage

On average, 1 gallon of CT- FloorStrip HP diluted at 1:4 will cover approximately 500 square feet.